B1Ll Posted March 29, 2009 Report Posted March 29, 2009 1. Click on "Start" in the bottom left hand corner of screen2. Click on "Run"3. Type in "command" and hit okYou should now be at an MSDOS prompt screen.4. Type "ipconfig /release" just like that, and hit "enter"5. Type "exit" and leave the prompt6. Right-click on "Network Places" or "My Network Places" on your desktop.7. Click on "properties"You should now be on a screen with something titled "Local Area Connection", or something close to that, and, if you have a network hooked up, all of your other networks.8. Right click on "Local Area Connection" and click "properties"9. Double-click on the "Internet Protocol (TCP/IP)" from the list under the "General" tab10. Click on "Use the following IP address" under the "General" tab11. Create an IP address (It doesn't matter what it is. I just type 1 and 2 until i fill the area up).12. Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers.13. Hit the "Ok" button here14. Hit the "Ok" button againYou should now be back to the "Local Area Connection" screen.15. Right-click back on "Local Area Connection" and go to properties again.16. Go back to the "TCP/IP" settings17. This time, select "Obtain an IP address automatically"18. Hit "Ok"19. Hit "Ok" again20. You now have a new IP addressWith a little practice, you can easily get this process down to 15 seconds.*Note* This only changes your dynamic IP address, not your ISP/IP address. Quote
skyner Posted March 31, 2009 Report Posted March 31, 2009 mult mai simplu...dupa ipconfig /release scrii ipconfig /renew si tadaa:) Quote