Search the Community

This will be the shortest tut made by me because need only few changes. On the begin we will install VLAN packet. This will be done using command: # apt-get install vlan -y After this we will load 8021q module into the kernel using command; # sh -c 'grep -q 8021q /etc/modules || echo 8021q >> /etc/modules' Now the only thing required is to add VLANs into the /etc/network/interfaces file as next example: auto eth1 iface eth1 inet static address 192.168.0.101 netmask 255.255.255.0 network 192.168.0.0 broadcast 192.168.0.255 gateway 192.168.0.254 dns-nameserver 8.8.8.8 # VLAN 69 auto vlan69 iface vlan69 inet static address 172.16.69.25 netmask 255.255.255.248 network 172.16.69.24 broadcast 172.16.69.31 vlan_raw_device eth2 # VLAN 96 auto vlan96 iface vlan96 inet static address 10.10.96.1 netmask 255.255.255.0 network 10.10.96.0 broadcast 10.10.96.255 mtu 1500 vlan_raw_device eth2 Now for the job to be done we will restart networking and all will be done # /etc/init.d/networking restart * Reconfiguring network interfaces... ssh start/running, process 1400 Set name-type for VLAN subsystem. Should be visible in /proc/net/vlan/config Added VLAN with VID == 69 to IF -:eth2:- ssh stop/waiting ssh start/running, process 1465 Set name-type for VLAN subsystem. Should be visible in /proc/net/vlan/config Added VLAN with VID == 96 to IF -:eth2:- ssh stop/waiting ssh start/running, process 1530 [ OK ] To check if are up we will read file vlan/config using command # cat /proc/net/vlan/config. The output will be the next if all is good. VLAN Dev name | VLAN ID Name-Type: VLAN_NAME_TYPE_PLUS_VID_NO_PAD vlan69 | 69 | eth2 vlan96 | 96 | eth2 Author: razvan1@hy